Safety Instructions - Atag OX6411F Mode D'emploi

SAFETY INSTRUCTIONS

Installation of this oven must be performed only by
a licensed electrician. The installer is responsible
for connecting the appliance to the mains power
supply in observance of the relevant safety
recommendations.
Electrical safety
If the oven has been damaged in transport, do not
connect it.
• This appliance must be connected to the mains
power supply only by a specially licensed
electrician.
• In the event of a fault or damage to the
appliance, do not attempt to operate it.
• Repairs should be performed by a licensed
technician only. Improper repair may result in
considerable danger to you and others. If your
oven needs repair, contact the Atag Customer
Service or your dealer.
• If the supply cord is defective, it must be
replaced by a special cord or assembly available
from the manufacturer or an authorised service
agent.
• Electrical leads and cables should not be allowed
to touch the oven.
• The oven should be connected to the mains
power supply by means of an approved circuit
breaker or fuse. Never use multiple plug
adapters or extension leads.
• The rating plate is located inside the oven on the
right side.
• The power supply of the appliance should be
turned off when it is being repaired or cleaned.
• Take care when connecting electrical appliances
to sockets near the oven.
EN 11