Operation - DS Produkte C320-70 Mode D'emploi

Inserting / removing the telescopic tube
Adjusting the length of the telescopic tube
A
Mounting / removing suction nozzles
• Insert the free end of the telescopic tube as far as it will go into one of the suction
nozzles supplied. At the same time twist the nozzle gently backwards and forwards.
• For greater fl exibility the suction nozzles can also be connected directly to the suc-
tion hose without using the telescopic tube.
• To remove a suction nozzle simply pull it out.

Operation

ATTENTION!
■ During use, always keep the nozzles away from body parts or animals and don't
reach into the nozzles. You/they could be caught in the vacuum cleaner or injured.
If something does get caught in the vacuum cleaner, immediately turn off the device
( push the On / Off switch).
■ Only turn on the vacuum cleaner once you are sure that all parts have been com-
pletely assembled and that all fi lters are correctly inserted.
■ To ensure that the mains cable does not heat up during operation, pull at least two
thirds of its entire length out of the device housing before switching on the vacuum
cleaner. In order to avoid damage do not tug out the mains cable as far as it will go
(no further than the red mark on the cable)!
■ Always turn off the device and pull the mains plug out of the socket before you
change a nozzle or attach or remove any other accessories!
■ Do not under any circumstances vacuum up the following:
– liquids or wet materials (such as wet carpet shampoo)
– smouldering ashes, cigarette butts, matches etc.
– fl ammable or ignitable materials
– very fi ne dust (e. g. cement dust), ash or toner
– hard, pointy objects such as larger glass shards
19
• Insert the open end of the handle into the corresponding
opening of the telescopic tube. At the same time twist the
handle gently backwards and forwards. Afterwards, check
the connection for secure seating.
• To remove the telescopic tube, pull it out of the handle.
• Pull the slider (A) on the telescopic tube down and set the
desired length.
• Release the slider and move the tube forward until it locks
into place.
EN