Porsche Home Energy Manager Manuel D'utilisation page 69

Fig. 17 Energy manager web application (OVERVIEW)
Power sources
A
Current flow
B
Current consumer
C
Energy
D
Managing home installation
b Logged into the web application as Home user.
e
Configure home installation. HOME INSTALLA-
TION covers the following points, among others:
– Configuring the energy manager for current
consumers
– Prioritising and managing charging pro-
cesses if using several chargers
–
Enabling and disabling functions, such as
Overload protection, Own consumption op-
timisation and Cost-optimised charging
Adding an EEBus device
To ensure the energy manager functions correctly, it
is vital to connect it to an EEBus device, such as the
Porsche charger. If the energy manager and EEBus
device are in the same network, they can be paired.
b Logged into the Web Application as Home user.
b Energy manager and EEBus device are in the
same network with a strong enough signal
(home network or direct connection).
1. To start pairing, go to Home installation e Cur-
rent consumer and click on Add EEBus device.
�� Available EEBus devices are displayed.
2. Select the EEBus device by its name and ID
number (SKI).
3. Start pairing on the charger.
For information on adding the energy manager to the
charger, see the
g manual
Web Application of the Porsche Mobile Charger Con-
nect or Mobile Charger Plus.
g Pay attention to the charger operating instructions
.
Checking correct function
e
Using the Web Application, make sure the en-
ergy manager is functioning correctly. Too do
this, check that plausible values are shown for
power sources and consumers in the Overview.
Operating
67