Porsche Home Energy Manager Manuel D'utilisation page 59

Option Explanation
Phase The phase that will be
measured by the current
sensor in the given connec-
tion position (CTx).
Current sensor Name of the installed cur-
rent sensor.
See the designation on the
current sensor.
Current limit [A] The current limitation of
the line fuse to which the
current sensor is connec-
ted.
The value you enter (in
amps) must be lower than
the rated current of the
fuse.
3. Configuring power sources
Define the connected current sensor for each phase
of the house connection and for other power sources
at the place of use, e.g. photovoltaic system.
e
Assign a current sensor to each phase.
If a photovoltaic system is installed, this must also be
entered as a power source:
1. Enable Photovoltaic.
2. Assign the relevant phase and current sensor.
Information
Additional current sensors are available as spare
parts from your Porsche partner.
4. Entering current consumers
Enter all current consumers, e.g. garage, sauna, and
EEBus devices, e.g. Porsche Mobile Charger Connect,
Porsche Mobile Charger Plus, here and assign the
current sensors to the appropriate phases.
EEBus describes a communication protocol that is
integrated in the Porsche Mobile Charger Connect
charger, for example. If both the energy manager
and an EEBus device are in the same network, the
protocol enables both devices to be paired.
It is important to note the following requirements
when adding a consumer:
– The current consumer or EEBus device must
have a current sensor for each phase.
–
The number of phases in the supply cable of
the EEBus device are known and are configured
accordingly.
–
The mains phase of the charger is the vehicle
phase. Exception: The charger does not have
the same number of phases as the vehicle. For
example: The charger of a two-phase vehicle
should be configured as a two-phase EEBus de-
vice.
For each of the current consumers shown here, the
power supply can be displayed in the Overview and
History.
Adding current consumers
1. Select Add current consumer.
2. Select and configure:
Option Explanation
Name Name of current consumer
Type Set as current consumer in
the home as standard
Mains phases The number of phases used
by the current consumer
Assign current Select the current sensor
sensor to a phase. that is connected to the ca-
ble to the consumer
Displaying house connection phases as current
consumers
Instead of listing current consumers here, you can
also add the individual phases of the house connec-
tion. This will enable phase-specific consumption to
be displayed in the Overview.
To do this, enter the following settings:
1. Select Add current consumer.
2. Enter a name for the fictitious current consumer,
e.g. L1, L2 and L3).
3. Select Single phase as the mains phase.
4. Assign the current sensor that measures this
phase to the house connection.
Adding an EEBus device
b EEBus devices, e.g. Porsche Mobile Charger Con-
nect charger, Porsche Mobile Charger Plus, are in
the same network.
b The EEBus device is switched on and not in
standby mode.
Start-up
57