Using Programs; Reading The Values Of A Program: E.g. Speed - Kinetec Breva V01.0 Manuel D'utilisation

11.10.

Using Programs

The device Kinetec Breva™ allows you to store up to 16 programs (numbered 1 to 16), including
the type of movement, ROM, speed, force, pauses and timer.
The original parameter values of the program are empty. These values can be modified and
saved at any time (see 'To enter a program', page 9)
Beginning
To stop the unit
To access program mode
To change the program if necessary
To exit and confirm the selected program
To exit without confirming the selected
program
To start the unit
11.11.

Reading the values of a program: e.g. SPEED

Beginning
To stop the unit
To access program mode
To change the program if necessary
To read the speed value
After 5 seconds or after pressing on another
key
To exit and confirm the selected program
To start the unit
Comments:
• The values shown in the 'Display' column are examples. They actually depend on the stored
programs.
• The current movement parameters can be changed while using that program but no data will
be stored in the original program. See programming mode (page 9) to modify programs.
Kinetec Breva™
Keys to
Display
press
PL/FLEX DOR/FLEX
20 STOP 5
PROGRAM 1
EMPTY
PROGRAM 10
or
20 PL/DOR
PL/FLEX PL/FLEX
20 STOP 5 0
PL/FLEX DOR/FLEX
20 STOP 5
PL/FLEX PL/FLEX
20 STOP 10 0
Keys to
Display
press
PL/FLEX PL/FLEX
20 STOP 10 0
PROGRAM 1
EMPTY
PROGRAM 10
or
20 PL/DOR
PROGRAM 10
SPEED:
PL/FLEX PL/FLEX
20 STOP 10 0
PL/FLEX PL/FLEX
20 STOP 10 0
PL/FLEX PL/FLEX
20 STOP 10 0
EN
Remarks
Check that the hand control is not
20
locked (see page 7).
The program number blinks.
The new program number blinks.
0
The current parameters are those
recorded in program 10.
Back to the starting parameters.
20
The angle display changes with the
current movement.
Remarks
Check that the hand control is not
locked (see page 7).
The program number blinks.
The new program number blinks.
0
Displays the speed value.
1
The current parameters are those
recorded in program 10.
The angle display changes with the
current movement.
11/20