Unpacking And Packing; Installing The Device - Kinetec Breva V01.0 Manuel D'utilisation

7. Unpacking and packing

Unpacking
When you unpack the machine, don't forget
that you may need to pack it up again. We
recommend that you keep the packaging
materials, boxes and plastic bags.
Recommendations for plastic bags: do not put
them over the head as there is a risk of
suffocation, and keep them out of the reach of
children.
Be careful with small-sized pieces: they could
be swallowed by a child.
Be careful with cables and wires: risk of
strangulation.
Your machine is ready to be connected to the
power supply. (See page 6)
Packing
To prevent any problems when the machine is transported, only
pack it using its original packaging.
- Stop the motor at 0°
- Remove all accessories from the machine
- Set the leg extension to its minimum length
- Fold up the central bar and tighten the fastening knob
- Place the machine's base in the bottom box (step 5)
- Place the straps in the free space (step 4)
- Place the second box, containing the unit's other accessories

8. Installing the device

The device Kinetec Breva™ machine is designed to be used in hospitals, clinics, doctors' offices
or in private homes (rental).
The Kinetec Breva™ machine can be used with a physiotherapy table, a healthcare bed, a bed
or a chair.
The machine must be installed on a flat surface that is wide enough to accommodate the entire
device plus the other leg.
If a chair is used, we recommend checking whether the floor is slippery in order to ensure that
the machine does not move during the session.
We do not recommend using the machine with a bench.
We do not recommend the use of an air mattress.
Kinetec Breva™
EN 4/20