Using Programs - Kinetec Spectra Manuel D'utilisation

The KINETEC Spectra allows you to store up to 16 programs, including the type of treatment, ROM, speed, load, pauses and timer.
The original parameter values of the program are empty.
These values can be modified and recorded at any time (see 'How to enter a program' page 10).
Beginning
To stop the unit
To access the program mode
To change the program if necessary
To exit and validate the selected program
To exit without validation of selected program
Start the unit
Comments:
• The values shown in the 'Display' column are examples. They actually depend on the stored programs.
• The current movement parameters can be changed while using that program but no data will be stored in the original program.
See the programming mode (p 10) to modify programs.
Keys to press
KINETEC
40 STOP
PROGRAM
70 WARMUP
PROGRAM
or
25 warmup
KINETEC
Please wait
KINETEC
40 STOP
warmup
25 run
Display
Check if the hand control is not blocked
(See page 7).
15 110
1
The program number blinks.
110
3
The new program number blinks.
90
The current parameters have been recorded in
program 3.
Back to the starting parameters.
15 110
The value change at the speed of the
20 90 movement.
Use of the hand control

Using Programs

Remarks
GB
13