How To Use The Warm Up Key - Kinetec Spectra Manuel D'utilisation

Beginning
To stop the unit
To select the Warm Up mode
Start the movement
Warm Up rules:
The Kinetec Spectra starts at 70% of the full ROM, increasing 5% of the range every
other cycle until the pre-set ROM is reached.
Comments:
- The parameters modification should always be done while the unit is sopped.
- Pauses and By-Pass mode are not available during warm up cycles.
- The Warm Up cycles are only working when the movement is firstly run.
- To start new Warm Up sessions press twice the « Warm Up » key.
- The calculation mode used enables reaching the pre-set ROM in approximately seven full cycles.
Example:
For a Warm Up treatment with a pre-set ROM from 0° to 100°.
The first cycle starts from 15° to 85° to 15° and increase 5% each cycle.
Keys to press
KINETEC
40 STOP
PLEASE WAIT
WARM UP
30 STOP
WARM UP
15 RUN
100°

How to use the WARM UP key

Display
Check if the hand control is not blocked
15 110
(See page 7).
The display shows the default settings
(see page 8).
To change the movement value if necessary
see page 9.
15 90
The value change at the speed of the
15 110 movement.
50°
0°
Use of the hand control
Remarks
GB
15