How To Adjust The Basic Parameters Of The Movement; Kinetec Stop - Kinetec Spectra Manuel D'utilisation

Beginning
To stop the unit
To display the extension or flexion limit of the movement
To change the limit if necessary
To validate the new value, press another key
or wait more than 3 seconds.
Or
Or to display pause in extension or flexion limit
To change the pause if necessary
To validate the new value press another key
or wait more than 3 seconds. The display shows the
selected mode.
Keys to press
KINETEC
30 STOP
KINETEC
30 Ext
or
KINETEC
40 Flex
KINETEC
Or
40 Flex
KINETEC
SPEED 2
FORCE _ _ _ _ _ _
No timer
KINETEC
PAUSE HIGH
Pause low
KINETEC
Or
PAUSE low
KINETEC
40 STOP

How to adjust the basic parameters of the movement

Display
Check if the hand control is not blocked
15 90
(See page 7).
15 90
The value blinks.
15 90
The new value blinks.
15 110
While the value blinks press
the
to change if necessary.
Successive presses on this key selects the
0
pause at the extension or flexion limit.
0
The new pause value blinks.
15
The unit is ready to start with the new
15 110
parameters.
Use of the hand control
Remarks
or key
GB
9