How To Adjust The Basic Parameters Of The Movement - Kinetec Centura B&W Manuel D'utilisation

Using the hand control
To adjust the basic parameters of the movement
Beginning
To stop the unit
To choose the movement
To display the extension or flexion limit of the movement
To change the limit if necessary
To confirm the new value, press another key
or wait more than 3 seconds for automatic confirmation.
Or
To display the pause at the extension or flexion limit
To change the pause if necessary
To confirm the new value press another key or wait more
than 3 seconds. The display shows the selected mode
Comments:
• The values in the display column are given as an example.
Kinetec Centura B&W™
Keys to
Display
press
Arm straight
30 STOP
Arm FLEXED
50 STOP
Arm straight
30 STOP
Arm straight
30 Ext
or
Arm straight
20 FLEX
Arm straight
20 FLEX
or
Arm straight
SPEED 2
LOAD _ _ _ _ _ _
No timer
Arm straight
PAUSE HIGH
Pause low
Arm straight
PAUSE low
or
Arm straight
20 STOP
11/24
Check that the hand control is not locked (See
0 90
page 9).
0 90
The display shows the movement selected, with
the default settings.
0 90
0 90
The value blinks.
0 90
The new value blinks.
0 110
While the value blinks press
or
to change if necessary.
Successive presses on this key selects the
0
pause at the extension or flexion limit.
0
The new pause value blinks.
15
The unit is ready to start with the new
0 110 parameters.
Remarks
EN