Electrical Connection: Safety First; Starting The Unit - Kinetec Centura B&W Manuel D'utilisation

Electrical connection: safety first

2 versions of electrical protection are available for the device Kinetec Centura B&W™
machine. The identification label shows which version a machine is equipped with:
Type BF, Class II devices,
for home use, bear the following symbols:
Type B class I devices,
for use in a professional environment, bear the following symbol:
See page 22 for the meaning of the symbols.
Before connecting the device to the power supply, check that the mains voltage matches that shown on the identification plate
(100-240 V~ 50/60Hz) below the switch (18).
The connectors can be plugged in any one of the sockets
(the sockets are not assigned to a specific connector).
Connect the power supply cable (45).
IMPORTANT
For Type B Class I devices, and to avoid all risks of electric shock, the machine should only be connected to a
power supply that has protective earthing.
To connect the power supply, only use the original cable supplied with the machine.
Check that the cables remain free around the device so that they do not get damaged.
Check that the machine is not damaged, in particular the protective housings.

Starting the unit

Press the ON / OFF switch (18).
The indicator light (20) lights up, the machine carries out an auto-diagnostic, and
then the display shows in succession
Your Kinetec Centura B&W™ is ready to be used.
Warning Always check the motion parameters displayed on the hand control before starting the session.
:
Kinetec Centura B&W™ 8/24
18
45
20
EN