Using The Hand Control; Locking-Unlocking The Hand Control Setting; Start/Stop/Reverse Function; Procedure To Stop The Machine - Kinetec Centura B&W Manuel D'utilisation

Using the hand control

Locking-Unlocking the hand control setting

The hand control allows the patient to control the machine as appropriate.
The switch (19) has 3 positions:
Fully locked position
In this mode the only functions available are reading the operational settings and
using the START/STOP function.
Fully unlocked position
All adjustments are possible.
Half-locked position
In this mode, it is possible to switch the program and modify the
upper and lower movement limits. The START/STOP function is
always accessible.
Double locking
Simultaneously press the
The display shows "LOCK". To unlock the hand control, simultaneously press
the + and - keys; the display reads "UNLOCK".
You cannot change the parameters; if you try, the message "LOCK" will be displayed.
Note: the hand control locking is preserved when you switch the unit ON/OFF.

START/STOP/REVERSE function

As with all KINETEC
Press this key of the hand control and the movement stops.
Press this key of the hand control and the movement starts in the opposite direction.

Procedure to stop the machine

To stop the machine's movement: press the STOP key
To switch power off: press the ON / OFF switch (see page 8)
Kinetec Centura B&W™
+ and - keys to lock the hand control.
We recommend that you lock the hand control when you
give it to the patient.
systems, The device Kinetec Centura B&W™ is equipped with a START/STOP/REVERSE function.
®
IMPORTANT: for optimum safety, always give the hand control
to the patient before starting the system.
9/24
19
EN