Using Programs; Reading The Values Of A Program - Kinetec Spectra Manuel D'utilisation

Using Programs

Beginning
To stop the unit
To access program mode
To change the program if necessary
To exit and confirm the selected program
To exit without confirming the selected
program
Start the unit
Warning: Always check the motion parameters displayed on the hand control before starting
the device.
When a USB key is connected the programs stored on the USB key have priority.
Reading the values of a program: e.g. SPEED
Beginning
To stop the unit
To access program mode
To change the program if necessary
To read the speed value
After 5 seconds or after pressing another key
To exit and confirm the selected program
Start the unit
Note: The current movement parameters can be changed while using that program but no
data will be stored in the original program. See programming mode (page 11) to modify
programs.
When a USB key is connected the programs stored on the USB key have priority.
Kinetec Spectra™
Keys to
Display
press
KINETEC
40 STOP
PROGRAM
EMPTY
PROGRAM
30 WARM UP
Or
WARM UP
Please Wait
KINETEC
40 STOP
WARM UP
30 RUN
Keys to
Display
press
KINETEC
40 STOP
PROGRAM
EMPTY
PROGRAM
30 WARM UP
Or
PROGRAM
SPEED: 2
KINETEC
40 STOP
WARM UP
30 STOP
WARM UP
30 RUN
EN
Check if the hand control is not
45 110 locked (See page 7).
Nr1
The program number blinks.
Nr7
The new program number blinks.
90
The current parameters are those
recorded in program 7.
Back to the starting parameters.
45 110
The angle display changes with the
50 90
current movement.
Check if the hand control is not
45 110 locked (See page 7).
Nr1
The program number blinks.
Nr7
The new program number blinks.
90
Nr7
Displays the speed value.
45 110
The current parameters are those
45 90
recorded in program 7.
The angle display changes with the
50 90 current movement
Remarks
Remarks
12/20