Using Programs; Reading The Values Of A Program - Kinetec Breva Manuel D'utilisation

Use of the hand control

Using Programs

The KINETEC Breva allows you to store up to 16 programs, including the type of movement, ROM, speed, load, pauses
and timer.
The original parameter values of the program are empty.
These values can be modified and recorded at any time (see 'How to enter a program' page 8)
Beginning
To Stop the Unit
To access the program mode
To change the program if necessary
To exit and validate the selected program
To exit without validation of selected program
Start the unit
Reading the values of a program: example SPEED
Beginning
To Stop the Unit
To access the program mode
To change the program if necessary
To read the speed value
After 5 seconds or after pressing on another key
To exit and validate the selected program
Start the unit
Comments:
• The values shown in the 'Display' column are examples. They actually depend on the stored programs.
• The current movement parameters can be changed while using that program but no data will be stored in the original
program. See the programming mode (p 8) to modify programs.
GB
10
Keys to press
PL/FLEX
20 STOP
PROGRAM
PROGRAM
or
20
Pl/flex
20
PL/FLEX
20 STOP
Pl/flex
20 stop
Keys to press
Pl/flex
20 stop
PROGRAM
PROGRAM
or
20
PROGRAM
Speed :
Pl/flex
20 stop
Pl/flex
20 stop
Pl/flex
20 stop
Display
dor/FLEX
Check if the hand control is not locked
5 20 (See page 5).
1
The program number blinks.
empty
10
The new program number blinks.
PL/dor 0
pl/flex
The current parameters have been
stop 5 0 recorded in program 3.
dor/FLEX
Back to the starting parameters.
5 20
pl/flex
The value change at the speed of the
10 0 movement.
Display
pl/flex
Check if the hand control is not locked
10 0 (See page 5).
1
The program number blinks.
empty
10
To change the program if necessary.
PL/dor 0
10
Displays the speed value.
1
pl/flex
10 0
pl/flex
The current parameters have been
10 0 recorded in program 3.
pl/flex
The value change at the speed of the
10 0 movement.
Remarks
Remarks