Publicité
Les langues disponibles
Les langues disponibles
Safety instructions
■
Only specialist personnel are allowed to saw
trunks that are thicker than the length of the
chain bar.
■
Never carry and transport the chain saw with
the saw chain running.
■
When changing position, switch off the motor
and put on the chain guard.
■
Only use the mains cable for the designated
purpose.
■
Never lift or carry the chain saw with the
mains cable.
■
Do not pull the mains cable in order to pull the
mains plug out of the socket.
■
Protect the mains cable against damage and
dirt.
■
Only transport the chain saw by carrying it
with the handle - the chain bar must point
backwards during transport.
■
When chain saws are not in use, always put
on the chain guard and disconnect from the
mains.
■
Route the extension cable so that it cannot
become snagged during sawing.
■
Immediately switch off the chain saw and dis
connect it from the mains if you notice any
changes.
■
Always keep a first-aid kit to hand in case of
accidents.
■
Make sure that no saw chain oil gets onto the
ground.
■
Switch the chain saw off before putting it
down.
■
Determine the maximum handling period and
set breaks in the work according to the vibra-
tion value.
Danger o f kickback
DANGER!
Danger of fatal injury due to kickback!
Kickback can lead to fatal injuries!
Take measures to avoid kickback.
If kickback occurs, the chain saw is suddenly and
uncontrollably flung back towards the operator.
This situation arises in particular if the chain saw
encounters foreign bodies during work, or during
sawing with the tip of the chain bar.
Note the following points in order to avoid kick-
back:
■
Inspect the material to be sawn for foreign bo-
dies (nails, metal, etc.) and remove them.
440105 a
■
Only operate the chain saw with both hands.
■
Do not remove the chain saw from the cut un-
less the saw chain is running.
■
Do not bend too far forward when working
with the chain saw.
■
Never cut off several branches at once.
■
Do not work unless the saw chain is correctly
sharpened and tensioned.
■
Never operate the chain saw with outstret-
ched arms.
■
Start the cut with the saw chain running, and
only saw at full speed.
■
Do not saw with the tip of the chain bar.
■
Always keep the tip of the chain bar in sight.
■
Work with increased caution when continuing
cuts that have already been started.
■
Work with increased caution when cutting un-
dergrowth and young trees.
■
Do not saw when standing on a ladder or
above shoulder height.
■
Use the bumper spike for increased stability
when sawing.
■
Make sure you are standing securely when
sawing.
■
Chiefly saw with the underside of the bar.
Work with increased caution when sawing
with the top of the bar.
ASSEMBLY
CAUTION!
A
Danger of injury if the machine is incom-
plete!
Incomplete machines can lead to injuries
and damage to the machine!
Do not operate the machine unless it has
been fully assembled.
WARNING!
A
Danger of injury from the saw chain!
Sharp edges can cause serious lacerati-
ons!
Wear suitable gloves and disconnect the
mains plug when installing the saw chain
and chain bar.
Installing the chain bar
EKS 2000/35
ALKO
29
Publicité
