Gaggia Baby Twin Mode D'emploi page 23

ENGLISH
5 Switch on the machine by pressing the ON/OFF button (1).
(Fig.03) - Fill up (as described in section "Making hot
water" of the manual) two cups of water (about 150 ml
each) from the steam/hot water wand, then turn off the
machine by pressing the ON/OFF button (1).
6 Leave the descaling solution to descale for approx.15-20
minutes with the machine turned off.
7 Switch on the machine by pressing the ON/OFF button (1).
(Fig.03) - Fill up (as described in section"Making hot
water" of the manual) two cups of water (about 150 ml
each) from the steam/hot water wand. Then turn the
machine off by means of the ON/OFF button (1) and
leave it off for 3 minutes.
8 Repeat the operations as described in step 7 until the
water tank is completely empty.
9 (Fig.02) - Rinse the tank and fi ll it again with fresh
drinking water.
10 (Fig.03) - Place a container under the steam wand
(Pannarello). Press the button for dispensing hot water
(4); the indicator light of the button will start blinking.
Open the knob (25) slowly by turning it clockwise.
11 Dispense the whole water tank from the steam/hot water
wand. To stop dispensing, close the knob (25) by turning
it counter-clockwise and press the button (4) again.
12 (Fig.02) - Fill the tank with fresh drinking water.
13 Place a suitable container under the fi lter holder.
14 Press the brew button (6) and dispense all the water in
the tank. Once the water tank is empty, stop dispensing
by pressing the brew button again (6). At the end, empty
the container.
15 Remove the fi lter holder from the unit by turning it from
right to left and rinse it with fresh drinking water.
16 Repeat the operations once again from point (9) for a
total of 4 tanks. The machine is now ready to be used.
The descaling cycle is now complete.
(Fig.03) - Fill the tank again with fresh water. If necessary,
prime the circuit as described in section "Starting up" of
the manual.
Once fi nished, reposition the Pannarello (or Cappuccinatore)
on the steam wand.
• 20 •