Gaggia Baby Twin Mode D'emploi page 16

Description of parts:
FIG. 01
1 Main switch
2 Coffee dispensing button-1 strong/2 weak
3 Coffee dispensing button-1 weak/2 weak
4 Hot water supply button
5 Steam supply light
6 Dose programming/Manual dispensing button
7 Correct temperature light
8 Turbo frother steam nozzle (removeable)
9 Filterholder
10 "Perfect crema" pod filter
11 "Perfect crema" filter for ground coffee
12 Basin (removable)
13 Frothing jet device
14 Brewing head
15 Filterholder gasket
16 Shower disc holder
17 Shower disc
18 Tamper
19 Power cable and plug
20 Measuring spoon
21 Delivery spout
22 Tank cover
23 Grid (removable)
24 Cappuccino maker kit (OPTION)
25 Steam/hot water knob
26 Removable water tank
27 Overflowing protection hole
28 Anti-fingerprint cleaner for stainless steel (OPTION)
29 Level indicator for the basin
Instructions for the power supply cord
A A short power-supply cord is provided to reduce risks of
getting tangled up or tripping over a longer cord.
B Longer extension cords are available and may be used if
care is exercised in their use.
C If a long extension cord is used:
1 the marked electrical rating of the extension cord
should be at least as great as the electrical rating
of the appliance.
2 if the appliance is of the grounded type, the
extension cord should be a grounding-type 3-wire
cord, and the longer cord should be arranged so
that it will not drape over the counter top portable
top where it can be pulled on by children or tripped
over;
3 If the power supply cord has a polarized plug (one
blade is wider than the other), as a safety feature,
this plug will fi t in a polarized outlet only one way.
If the plug does not fi t fully in the outlet, reverse
the plug. If it still does not fi t, contact a qualifi ed
electrician. Do not attempt to defeat the safety
feature.
4 If damaged, the power cord must be replaced by
the manufacturer or an authorised service centre.
Preparation:
1. Remove the water tank cover (22) and fill with cold water
to the MAX line indicated on tank (26). See FIG. 2.
N.B.: Near the word MAX on the tank there is the overflowing
safety hole (27) in case of tank overfilling.
The water tank can also be removed, after removing the
tank cover (22) using the handle.
Re-install tank with water and cover (22).
2. Insert plug (19) into a suitable wall outlet (see point 1
under "Caution").
3 Push the main switch (1). The temperature light (7)
will flash until the temperature is reached; when the
temperature is reached the light will remain on.
The lights of buttons 2 - 3 - 5 - 6 will remain on in a fixed
way (stand-by mode).
• 13 •
ENGLISH