Measuring Blood Pressure - Beurer Bm 19 Mode D'emploi

The time is shown in 24 hour format. The device also has five
languages. The device is set to German on delivery. Proceed
as follows to set the date, time and language:
Press the memory key (M) for over 5 seconds.
The day starts flashing. Use the +/- key to set the day from 1
to 31 and confirm with the memory key (M).
Set the month, hour and minute and confirm in each case
with the memory key (M).
After setting the date and time you can set the language.
Use the + and - volume keys to select the following languag-
es: L1 = German, L2 = English, L3 = French, L4 = Spanish,
L5 = Russian, L0 = no language. Confirm your selection with
the memory key (M).
You can then set the volume of the selected language:
Vol 3 = high, Vol 2 = medium, Vol 1 = low. Confirm your se-
lection with the memory key (M).
Note: Language off (L0) means that voice output is not se-
lected and the measurement value will not be announced.
Mains operation
You can also operate this device with a mains adapter. No bat-
teries should be in the battery compartment for this. The mains
adapter is available from retailers or from the service address
under order no. 071.13. The blood pressure monitor should
only be used with the mains adapters specified here. The
mains adapter should only be connected to the mains voltage
indicated on the rating plate. Once you have disconnected the
device from the mains, the date and time on the blood pres-
sure monitor are lost. Any measurement results that have been
stored are however retained.

5. Measuring blood pressure

Positioning cuff
Fit the cuff round your bare left up-
per arm. Blood circulation in the
arm should not be restricted by tight
clothing or other objects.
The cuff should be placed on the
upper arm so that the lower edge
is 2 to 3 cm above the bend of the
elbow and above the artery. The tube
should be in line with the centre of
the palm.
Now place the free end of the cuff
snugly, but not too tightly, around
the arm, and fix it with the Velcro fas-
tener. The cuff should be fitted tight
enough to allow just two fingers to fit
beneath the cuff.
Insert the cuff tubing into the socket
for the cuff attachment.
Important: The instrument should only be operated with the
original cuff. The cuff is suitable for an arm circumference of
23 to 33 cm.
14