Scheppach DP18VARIO Traduction Des Instructions D'origine page 29

• Keep your hands away from the work area, when the
machine is in operation.
Before maintaining or adjusting, switch off the machine
and unplug the power plug.
6. Technical data
Rated input voltage
Nominal power
Motor speed
Output speed (continu-
ously adjustable)
Chuck adapter
Drilling spindle cone
Chuck
Drilling table size
Angle adjustment
Drilling depth
Column diameter
Height
Weight
Laser class
Laser wavelength
Power of laser
Noise and vibration
The noise levels have been determined in accordance
with EN 61029.
Sound pressure level Idle L
Sound pressure level L
pA
Uncertainty K
pA
Sound power level Idle L
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
Excessive noise can result in a loss of hearing. Total
vibration values (vector sum of three directions) deter-
mined according to EN 61029.
230-240 V~ 50 Hz
550 W
1450 min
440 - 2580 min
B16
MT2
1 - 16 mm
240 x 240 mm
45° - 0° - 45°
80 mm
65 mm
713 mm
38,5 kg
650 mm
1mW
70.2 dB(A)
pA
73.5 dB(A)
3 dB(A)
82.7 dB(A)
WA
86.3 dB(A)
3 dB(A)
www.scheppach.com
Vibration emissions value ah = 1,7 m/s
Uncertainty K = 1,5 m/s
The specified vibration emission value has been meas-
ured according to a standardised testing procedure
and can be used for comparison of one power tool with
another; and may change depending on the way in
which the power tool is used and in exceptional cases
may be higher than the specified value.
The specified vibration emission value can be used to
-1
compare one power tool with another.
-1
The specified vibration emission value can also be
used for an initial estimation of the impair.
7. Before commissioning
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, keep the packaging until the expiry of
the warranty period.
2
ATTENTION
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
8. Assembly
Column and machine foot, fig. 3
1. Set the machine foot (1) down on the ground or
the workbench.
2. Place the column (2) on the base plate so that the
holes on the column (2) align with the holes on the
base plate (1).
3. Screw the four hexagonal screws (19) to fasten the
column into the base plate and tighten them using
a hexagon spanner (A).
Removing the rack, fig. 4
In order to install your drill, you must first remove the
rack (E).
1. Use an Allen key (WAF3) to remove the ring (F)
and pull this off the column (2).
2
2
GB | 29