Scheppach DP18VARIO Traduction Des Instructions D'origine page 26

• 1 Chuck
• 1 Column
• 1 Machine foot
• 1 Crank handle
• 1 Operating manual
4. Proper use
The bench drill is designed for drilling in metal, wood,
plastic and tiles. Straight shank drills with a drilling
diameter of 3 mm to 16 mm can be used.
The device is intended to be used by do-it-yourselfers.
It was not designed for heavy commercial use. The tool
is not to be used by persons under the age of 16. Chil-
dren over the age of 16 may use the tool except under
supervision. The manufacturer is not liable for damage
caused by an improper use or incorrect operation of
this device.
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the machine is used
in commercial, trade or industrial businesses or for
equivalent purposes.
5. Safety instructions
m ATTENTION! The following basic safety measures
must be observed when using power tools for protec-
tion against electric shock, and the risk of injury and
fire. Read all these notices before using the electric
tool and store the safety instructions well for later ref-
erence.
General safety instructions
m ATTENTION! The following basic safety measures
must be observed when using power tools for protec-
tion against electric shock, and the risk of injury and
fire: There is a risk of injuries.
General safety instructions for electric tools
m WARNING! Read all safety information and in-
structions. Failure to observe safety information and
instructions can result in electric shock, fire and/or
serious injuries.
Store all safety instructions and information for
future reference.
The term "power tool" used in the safety instructions
refers to mains-powered power tools (with a mains
cable) and battery-powered power tools (without a
mains cable).
26 | GB
Safe work
• Keep the work area orderly
- Disorder in the work area can lead to accidents.
• Take environmental influences into account
- Do not expose power tools to rain.
- Do not use power tools in a damp or wet environ-
ment.
- Make sure that the work area is well-illuminated.
- Do not use power tools where there is a risk of
fire or explosion.
• Protect yourself from electric shock
- Avoid physical contact with earthed parts (e.g.
pipes, radiators, electric ranges, cooling units).
• Keep other persons away
- Do not allow other persons, especially children,
to touch the power tool or the cable. Keep them
away from your work area.
• Securely store unused electric tools
- Unused power tools should be stored in a dry,
elevated or closed location out of the reach of
children.
• Do not overload your power tool
- They work better and more safely in the specified
output range.
• Use the correct power tool
- Do not use low-output machines for heavy work.
- Do not use the electric tool for purposes for which
it is not intended. For example, do not use hand-
held circular saws for the cutting of branches or
logs.
• Wear suitable clothing
- Do not wear wide clothing or jewellery, which can
become entangled in moving parts.
- When working outdoors, anti-slip footwear is rec-
ommended.
- Tie long hair back in a hair net.
• Use protective equipment
- Wear protective goggles.
- Wear a mask when carrying out dust-creating
work.
• Connect a dust extraction system
- If connections for dust extraction and a collect-
ing device are present, make sure that they are
connected and used properly.
• Do not use the cable for purposes for which it
is not intended
- Do not use the cable to pull the plug out of the
outlet.
- Protect the cable from heat, oil and sharp edges.
www.scheppach.com