Scheppach DP18VARIO Traduction Des Instructions D'origine page 32

Attention! Metal parts must be clamped so that they
cannot be pulled up. Depending on the workpiece, cor-
rectly adjust the height and inclination. There must be
enough distance between the top of the workpiece and
the tip of the drill.
Laser operation, fig. 21
Switching on: Move the on/off switch laser (28) into
the "I" position to switch on the laser. Two laser lines
are projected onto the workpiece to be processed, the
intersection of which indicates the centre of the drill tip.
Switching off: Move the on/off switch laser (28) into
the "0" position.
Working light operation, fig. 21/22
Note: Always ensure good lighting at the work station.
Switching on: Move the on/off switch (29) into the "I"
position to switch the working light (30) on.
Switching off: Move the on/off switch (29) into the "0"
position.
Working speed
Ensure correct speed during drilling. This depends on
the drill diameter and the material.
The list below will help you choose speeds for different
materials.
The speeds indicated are only guidelines.
Drill Grey Steal
diam- cast
eter iron
3 2550 1600
4 1900 1200
5 1530 955
6 1270 800
7 1090 680
8 960 600
9 850 530
10 765 480
11 700 435
12 640 400
13 590 370
14 545 340
16 480 300
18 425 265
32 | GB
Iron Alu- Bronze
mini-
um
2230 9500 8000
1680 7200 6000
1340 5700 4800
1100 4800 4000
960 4100 3400
840 3600 3000
740 3200 2650
670 2860 2400
610 2600 2170
560 2400 2000
515 2200 1840
480 2000 1700
420 1800 1500
370 1600 1300
www.scheppach.com
20 380 240
22 350 220
25 305 190
Countersinking and pilot drilling
With this bench drill you can also countersink or pilot
drill. Please note that countersinking should be carried
out at the lowest speed, while a high speed is required
for pilot drilling.
Woodworking
Please note that suitable dust extraction must be used
when working with wood, as wood dust can be hazard-
ous to health. Wear a mask when carrying out dust-cre-
ating work.
10. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The cus-
tomer's mains connection as well as the extension
cable used must also comply with these regula-
tions.
Important information
In the event of overloading, the motor will switch itself
off. After a cool-down period (time varies) the motor
can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
335 1400 1200
305 1300 1100
270 1150 950