Publicité
Les langues disponibles
Les langues disponibles
Mowing deck:
- wash the inside including the part of the ejection chute
- slide a hose of a suitable diameter on to the fittings on the mowing deck cover. Start the
engine, engage the mowing deck and flush out the mowing deck with a current of water
for 10 minutes.
This flushing procedure needs to be performed at the end of every mowing session.
Avoid washing with water in the vicinity of electrical accessories on the control panel, battery, etc.
6.3 REGULAR CHECKS, MAINTENANCE AND ADJUSTMENTS
6.3.1 BATTERY
Correct and regular maintenance of the battery will extend its lifespan. Therefore regularly check its
condition according to the manual supplied by the battery's manufacturer.
Keep the battery contacts clean. If dirt accumulates on them, or they are rusty, clean them according to
the recommendations of the battery's manufacturer. Interruption of the circuit caused by the oxidation
of the contacts may lead to the malfunction of the recharging function of the engine!
A flat battery needs to be recharged as soon as possible, otherwise its cells may be irreparably damaged.
It is always necessary to charge the battery before:
- first use
- when not planning on using it for a long time
- before starting up after a longer break
- in other cases, specified in the user's manual of the battery drawn up by its manufacturer.
If it is necessary to replace the battery, always use a battery of the same size and type.
Further details about checking and maintaining batteries are included in a separate
user's manual supplied by the battery's manufacturer.
6.3.2 ENGINE
Í CHANGING OIL
Before changing the oil, prepare a container with a volume of at least
2 litres. So that all the oil flows out of the engine we recommend that
you place something (e.g. wooden blocks) under the side opposite the
drain screw. Drain the oil while it is still warm.
Unscrew the filler opening of the oil so that the oil flows better and
faster out of the engine.
Unscrew the drain screw and allow the oil to fully flow out into the
prepared container.
Screw the drain screw back on and fill the engine with the correct
amount of the recommended oil (
and close the oil filler cap.
Use the dipstick to check the correct oil level. If necessary fill up the
oil so that the oil is at the correct level.
Further details about replacing oil as well as its type and amount are included in a separate
user's manual supplied by the engine's manufacturer.
- If you come into contact with used oil, we recommend that you thoroughly wash your hands
with soap and water.
- Dispose of used oil according to environment protection laws. It is appropriate to deliver the
oil in a closed container to a used oil collection point. Under no circumstances should dispose
of the used oil with other waste or pour it down the drain, on to waste or on the floor.
User's manual for the engine)
99
6.2.2
Publicité
