Publicité
Les langues disponibles
Les langues disponibles
Í MAINTENANCE OF THE AIR FILTER
Never allow the engine to run without an air filter. This rapidly wears out the engine.
Maintain the air filter according to the instructions contained in the user's manual for the
engine supplied by its manufacturer.
Í MAINTENANCE OF THE SPARK PLUG
For the engine to run perfectly the spark plug must be correctly set and clean from deposits.
- Always use only the spark plug specified by the engine's manufacturer!
- If the engine was running shortly before the inspection or replacement, then the spark plug
will be very hot. So be very careful not to burn yourself.
Take off the spark plug cable and remove the spark plug using a wrench key.
Visually inspect the exterior appearance of the spark plug. If the spark plug
is visibly significantly worn out or if the insulator is cracked or it is peeling,
it is necessary to replace it.
If the spark plug is soiled or only slightly worn, it is necessary to carefully
clean it with a suitable wire brush (copper).
Using a gauge measure set the distance of the electrodes (
for the engine).
After performing maintenance on or replacing the spark plug, pull it tight in
position. An incorrectly tightened spark plug heats up significantly and may
cause serious damage to the engine.
Check, maintain and replace spark plugs according to the instructions contained in the
user's manual for the engine supplied by its manufacturer.
Í REPLACEMENT OF THE FUEL FILTER
Never allow the engine to run without an air filter. This rapidly wears out the engine.
Replace the fuel filter according to the instructions contained in the user's manual for the
engine supplied by its manufacturer.
6.3.3 REPLACING LIGHT BULBS
Light bulbs are seated in a bayonet catch and are accessible after lifting the hood.
Type of light bulb used:
Halogen light bulb MR16 12V / 20W GU5.3
When replacing the halogen light bulbs first press the tab (1) and slide the bulb out of
the socket (2). For installation proceed in the reverse sequence.
When replacing a light bulb, always use the same type of light bulb or an equivalent
recommended by the light bulb vendor!
6.3.4 REPLACING A FUSE
If a fuse is damaged the engine will immediately shut off, the mowing deck will stop and all indicator
lights on the dash board will turn off. In this case it is necessary to find the faulty fuse and replace it
with a new one. Under no circumstances should you replace a faulty fuse with a fuse that has a higher
current rating!
User's manual
100
6.3.3a
Publicité
