Publicité
Les langues disponibles
Les langues disponibles
6.2.1 BEFORE STARTING WORK
Í INSPECTION OF TYRE PRESSURE
Maintain the prescribed tyre pressure and check it regularly. Maintaining the prescribed tyre pressure
is important for even mowing. Different pressure values may cause difficulty in driving, or even loss of
control over the machine.
Tyre pressure differs according to the type used. The correct tyre pressure is always provided on the
tyres.
Í INSPECTION OF THE OIL LEVEL IN THE ENGINE
Park the riding mower on a horizontal surface. Open the hood and unscrew the cap of the filling opening.
Screw out the oil dipstick, wipe it dry, reinsert it and screw in. Then again screw it out and take the oil
level reading.
The oil level must be between the two marks on the dipstick. If it is not, fill up with motor oil so that it
reaches the "FULL" mark.
Further details about checking and filling of oil are included in a separate user's manual
supplied by the engine's manufacturer.
Í INSPECTION OF CABLES AND BOLT CONNECTIONS
Visually inspect the condition of cables and manually check the tightness of bolt connections.
Í INSPECTION OF WORKING ORDER OF BRAKES
Check that the brakes work properly. Proceed as follows:
Park the machine on an even surface and turn off the engine.
Step on the brake pedal and engage the parking brake.
Using the by-pass lever disengage the rear wheel drive.
Try to push the machine forward. If the rear wheels rotate, then the brakes need to be serviced.
Contact an authorised service centre to have them adjusted.
Í INSPECTION OF THE WORKING ORDER OF SAFETY ELEMENTS
Before every use of the riding mower, check the working order of safety elements:
switch under the seat
"R" switch for deactivation of the mowing deck disengagement for reversing
6.2.2 AFTER FINISHING WORK
Í CONFIGURING THE MACHINE
After finishing mowing, elevate the mowing deck to the highest position and disable the drive for the
mowing blades.
Turn off the ignition, step on the brake pedal and secure the machine in position with the parking brake.
On machines with a BS15 engine(15.5 HP) close the fuel supply.
Í CLEANING THE MACHINE
Remove all dirt and grass remains from the surface of the tractor, the ejection chute and the mowing deck.
Thoroughly clean the textile sack of the grass catcher. When it is clogged with grass, the ability of the
machine to fill the grass catcher is reduced.
Í WASHING THE MACHINE
Before washing, park the machine on a suitable even surface.
Grass catcher:
- remove the grass catcher from the machine, wash it and allow it to dry naturally.
Plastic parts on the machine:
- clean using a sponge and soapy water
98
Publicité
