Publicité
Les langues disponibles
Les langues disponibles
When attaching the rear wheel pay attention to the mutual alignment of the pin on the shaft and the
groove on the wheel.
6.3.15 REPAIRING A TYRE PUNCTURE
The machine is equipped with tubeless tyres. In the event of a puncture have it repaired at a specialised
tyre repair shop or at an authorised Seco machine service centre.
6.3.16 MAINTENANCE OF THE HYDROSTATIC TRANSMISSION
For the reliable operation of the transmission it is necessary to maintain the correct oil level. The filling
openings on the transmissions are accessible after taking the ejection chute off the machine (
Prescribed values are provided in the following table.
Type of transmission
HG T2
HG T3
In the event of problems with the transmission immediately seek the help of an authorised
service centre, there is a risk of serious damage.
6.3.17 OVERVIEW OF THE TIGHTENING TORQUE OF BOLT CONNECTIONS
Mowing deck:
Central blade bolt
Nuts M12 on the mowing drive pulleys
Bolt 10x25 KL 100 RIPP on the arm of the mowing drive belt tensioning pulley
Steering:
Bolt M8x30 of the steering segment
M12 nut of steering segment
Engine:
Bolt of the electromagnetic clutch
Bolt of the travel belt pulley holder
Wenn Sicherungsmuttern entfernt werden, müssen sie durch neue ersetzt werden.
Oil type
20W-50, API CD
20W-50, API CD
105
Oil level
1.5 - 3 cm from the filling opening
1.5 - 3 cm from the filling opening
6.3.10).
Torque
30 ± 3 Nm
45 - 55 Nm
55 - 65 Nm
15 - 25 Nm
35 - 45 Nm
60 - 70 Nm
25 - 35 Nm
Publicité
