Publicité
Les langues disponibles
Les langues disponibles
6.4 LUBRICATION
Lubricate the machine according to the following lubrication diagram.
Ball bearings of the tension pulleys, guide pulleys and bearings on the mowing deck are self-lubricating.
Before putting the machine out of service for an extended period, thoroughly lubricate all places shown
on the diagram. Namely the half axle of the front and rear axle (it is necessary to remove the rear
wheels).
Symbol
6.4
Plastic lubricant is used to lubricate:
angle joints connecting the steering draw bars - remove, lubricate
brake draw bar bolt - lubricate the draw bar in the vicinity of the bolt hole
mowing deck elevation draw bar bolt - lubricate draw bar in the vicinity of the bolt hole
angle joints connecting the steering draw bars - remove, lubricate
wheel pin angle joints - remove, lubricate
front wheel bearings
wheel pins passing through the axle
central pivot pin of the front axle - using a lubricating nipple
steering wheel shaft bearings - lubricate
cogged steering segment and eccentric – lubricate
front axle wheel pins for seating the front wheel.
rear half axle for seating the rear wheel
Pivot points are lubricated with oil:
brake pedal
Explanation
Plastic lubricant
Oil SAE 30
Interval in hours
106
Publicité
