Starting; Measures Prior To Starting; Setting Into Operation - Carrier GD60 Manuel D'instructions

Fig. 1
Fig. 2
1
Fig. 3
Fig. 4
2
1

5 Starting

5.1 Measures prior to starting

If the cabinet has been sharply tilted while
being sited or for mounting of accessories it
must be left to stand for at least three
hours before being started to allow the lubricating oil
to settle in the compressor! Failure to do so can cause
total destruction of the compressor refrigerating sys-
tem.

5.2 Setting into operation

Start the cabinet only if it has been installed
as described.
Plug power plug (1-1) in socket (1-2).
-
When selecting the socket, observe the re-
quirements stated in section 4.6. The cabinet
must not be plugged into a multiple-outlet
power strip (see fig. 2).
Switch on remote control switch if provided.
-
Starting is signalled by the low running noise of fans
and refrigeration systems. The fan is stopped by
switch (3-2) when door is opened.
Switch on cabinet lighting with switch (3-1) and
-
(4-1) on the underside of the display superstruc-
ture.
25