Publicité
Les langues disponibles
Les langues disponibles
• The cuff must be placed tightly around the wrist but
must not constrict.
5. Measuring blood pressure
• Sit in a relaxed position.
• Ensure that your arm is supported
and bend it so that it is at the level
of your heart (see illustration).
• Before measurement allow an
adequate relaxation time of 3 – 5
minutes.
• Now press the Start/Stop button 4 to start the meas-
urement.
• The cuff will now inflate automatically to 180 mmHg.
• When the 180 mmHg pressure is reached, the pres-
sure is automatically released from the cuff and a
beating heart appears in the display.
• If the preset pressure of 180 mmHg is inadequate
during inflation, the device automatically pumps up to
a higher pressure.
• Your blood pressure readings and pulse rate will then
appear in the display.
• To switch off and release the pressure, press the
Start/Stop button again 4 .
• If you forget to switch off the computer, it will switch
off automatically after 3 minutes.
• You can interrupt measurement at any time by pres-
sing the Start/Stop button 4 .
6. Display of the readings saved
The computer automatically saves the blood pressure
readings of the last 60 measurements.
• • • • • • • • • • • • •
When the 60 memory locations are exceeded, the current
oldest value is deleted.
You can display the memory as follows:
• Press the memory button M 3 with the computer
switched off. The last reading measured appears.
• You can call up all individual readings saved by press-
ing the memory button M repeatedly.
• The memory location number is shown in the display
at bottom right. The date and time of the individual
measurement are shown in the top part of the display.
• The last result obtained is stored in the first memory
location. As soon as a new result is obtained, this
appears in the first memory location and the older
result moves down to the next location.
15
Publicité
