Reely Phonix Plus Mode D'emploi page 39

c) Installing the Wing
The wings are installed in the fuselage slots on the left and right.
For this, push the enclosed wing connector (2) into one wing (1). The wing connector is later secured with one screw
each with the wing pushed on. To install the wing connector, these screws may need to be turned out a little at initial
assembly (see figure 5).
Push the wing connector (2) into the hole of the middle fuselage part.
Push the plug of the aileron servo against the counterpiece (3) of the wing holder. The servo plugs match the counter-
piece only in one position. Carefully push the wing half into the cut-out at the fuselage until the shaping of the wing is
flush with the fuselage. Observe that the servo cable is not caught and pushed into the fuselage.
Then install the second wing half on the fuselage in the same manner.
Figure 4
39