How To Change The Bag; Endless Bag Replacement For Class M And H Vacuum Cleaners - Nilfisk S2 L Manuel D'instructions

How to change the bag

WARNING!
■ These operations can only be carried out by
trained and qualified personnel who must wear
adequate clothing, in compliance with the laws in
force.
■ Take care not to raise dust during these
operations. Wear a P3 protective mask.
■ In case of dangerous and/or toxic dust, you must
use the supplied safety bag for these certified
vacuum cleaners.
■
The bag must only be disposed of by qualified
personnel and in compliance with the laws in
force.
WARNING!
Installing the wrong paper bag for the class of dust
to be vacuumed or incorrect installation, can create a
health risk for the persons exposed.
Endless Bag replacement for class M and
H vacuum cleaners
Figure 11
WARNING!
Take care not to raise dust when this operation is
carried out. Wear a P3 mask and other protective
clothing plus protective gloves (DPI) suited to the
hazardous nature of the dust collected, refer to the
laws in force.
■ Prepare the bag holder with the inside part upwards
and insert the Longopac inside the groove on it. Pull off
the Longopac inner end for at least 25 cm, put the strap
around the support as shown in the figure, tighten it by
leaving free the excess part of the inner end pulled off
previously. Properly arrange the excess Longopac inside
the groove (1).
■ Pull off the Longopac outer end, turn it down and close it
with the proper band (2-3).
■ Draw near the bag holder to be placed under the hopper
cone, insert the pins into the slots and turn the system to
lock it at the upper cylinder (4).
■ Pull down the bag closed by the band and lay it on the
tray. Then, by means of the 2nd supplied belt the inner
end 250mm long, removed earlier, above the gasket on
the hopper (5).
■ When the bag is full (Longopac
end with two clamps by fastening them at 50 mm one
from the other, then with a pair of scissors cut the bag
between the two clamps.
07/2018
) close the upper
®
9
How to replace the Dust Bag
Figure 12
■ Close the inlet by using the relevant cap (1).
■ Release the dust container.
■ Remove the Dust Bag and close it with the relevant cap
as shown in figure 11.
■ Insert a new bag, making sure the bag inlet is sealed.
■ Replace the dust container in the vacuum cleaner.
WARNING!
Only use suitable bags for the vacuum cleaner class
you are using.
How to replace the Safe Bag
Figure 13
■ Remove and put the vacuum hose in a safe and dust-
free place.
■ Close the inlet by using the relevant cap (1).
■ Release the dust container.
■ Close the Safe Bag by pulling the "guillotine" (2) seal.
■ Close the plastic bag hermetically using the relevant
band (3).
■ Use the sticky tape (4) to close the bottom of the plastic
bag.
■ Remove the relevant connection (5) of the bag from the
inlet.
■ Insert a new safe bag, making sure the bag inlet is
sealed.
■ Wrap the plastic bag around the dust container external
wall.
■ Replace the dust container in the vacuum cleaner.
WARNING!
Only use suitable bags for the vacuum cleaner class
you are using.
S2 / S3
GB
C343