Tightness Inspection; Disposal - Nilfisk S2 L Manuel D'instructions

Tightness inspection

Hoses check
Make sure the connecting hoses (Fig. 17) are in a good
condition and correctly fixed.
If the hoses are damaged, broken or badly connected to the
unions, they must be replaced.
When sticky materials are treated, check for possible clogging
along the hose, in the inlet and on the baffle plate inside the
filtering chamber.
Scrape inlet (2, Fig. 17) from the outside and remove the
deposited waste as indicated in figure 17.
Filtering chamber tightness check
If the gasket (1, Fig. 19) between the container (4) and the
filtering chamber (3) fails to guarantee tightness:
■ Loosen the four screws (2) that lock the filtering chamber
(3) against the vacuum cleaner structure.
■ Allow the filtering chamber (3) to lower down and tighten the
screws (2) once it has reached the tightness position.
If an optimal seal cannot be obtained and the gasket is torn or
cracked, etc. it must be replaced.

Disposal

Figure 19
Equipment marked with the crossed-out wheeled bin symbol
indicates that used electrical and electronic equipment should
not be discarded together with unseparated household
waste. To avoid negative effects on human health and the
environment the equipment must be collected separately at
the designated collection points.
Users of electrical and electronic household equipment must
use the municipal collection schemes. Please note that
commercially used electrical and electronic equipment, shall
not be disposed of via municipal collection schemes. We will
be pleased to inform you about suitable disposal options.
07/2018
13
S2 / S3
GB
C343