Ultradent Products VALO Cordless Mode D'emploi page 4

Instructions for Use:
1- R emove all components from the packaging and examine them. If anything appears to be damaged, return to the manufacturer.
2- Charge batteries before using the device (See section Charging and Changing Batteries).
3- Insert two fully charged batteries positive (+) end first.
4- Replace the battery cover.
5- The VALO Cordless handpiece will beep when powering on.
6- Select the desired mode (see section Quick Mode Guide).
7- Press power button to activate the light.
N
OTE: The VALO Cordless curing light is programmed to cycle from the Standard Power to the High Power to the Xtra Power mode in sequence. For example, to
change from the Standard Power mode to the Xtra Power mode, it is necessary to cycle into the High Power mode and then to the Xtra Power mode.
The VALO Cordless curing light stores the most recently used timing interval, and mode, and it will default back to this whenever the
modes are changed or if the batteries are removed.
SLEEP MODE: The VALO Cordless curing light will go into Sleep Mode after 60 seconds of inactivity, as indicated by a slow flashing of
the mode/status light. Picking up or touching the unit will wake-up VALO Cordless and automatically return it to the last setting used.
WARNING: Storage and Travel: If storing the VALO Cordless for periods longer than 2 weeks, or packing it for travel, always remove the
batteries. If batteries are left in the unit for long periods of time without recharging they may become nonfunctional or un-chargeable.
Charging and Changing Batteries
The VALO Cordless comes with 4 rechargeable lithium iron Phosphate batteries.
How to charge batteries
1. Plug charger into electrical outlet.
2. Insert batteries into charger with
positive (+) end pointed towards the
indicator lights on charger.
3. Green Lighs indicate batteries are
ready for use.
4. Batteries will take 1-3 hours
to charge. Leave batteries in charger
until ready for use.
How to change/insert batteries
1. Remove back cap by twisting counterclockwise
one quarter turn.
2. Remove batteries.
3. Insert fresh batteries positive (+) side first.
4. R eattach back cap by aligning and gently pushing
while twisting clockwise.
The cap will click when fully attached.
5. The unit is ready for use.
4