Ultradent Products VALO Cordless Mode D'emploi page 12

VALO Charger
VALO Batteries
VALO Cordless
WARNING: When sending units in for repair, service, or calibrations, always remove the batteries from the VALO Cordless and charger.
Wrap batteries, charger, adapter, and VALO Cordless separately in the return box.
WARNINGS and PRECAUTIONS
Read all instructions before operating this unit. The manufacturer accepts no liability for any damage resulting from the improper use of
this unit and/or for any purpose other than those covered by these instructions.
USER - PATIENT SAFETY WARNINGS:
• T he VALO Cordless curing light emits extremely high intensity light very similar to high intensity quartz halogen lights and must only be
used as indicated in this manual.
• D O NOT look directly into the light output. Patient, clinician and assistants should wear UV orange eye protection when this device is in
use.
• D O NOT expose soft oral tissues at close proximity. Maintain a safe distance between the lens and the soft tissue.
• I n Xtra Power Mode, DO NOT expose soft oral tissue for more than 9 seconds. The Xtra Power Mode has a 2 second safety delay to
limit oral tissue heating during consecutive curing. If a longer cure is needed, consider a dual-cure product (composite or adhesive).
• I f using the VALO Cordless curing light in close proximity of the gingival, DO NOT expose tissue for more than 20 seconds. If a
40-second cure is needed, allow 2 minutes between two 20 second cures. If longer curing time is required, consider a dual-cure.
PRODUCT SAFETY WARNINGS:
• D O NOT autoclave.
• D O NOT immerse in any kind of ultrasonic bath, disinfectant, cleaning solutions, or any kind of liquid.
• P RECAUTION: Static Electricity – This unit may be susceptible to strong magnetic or static electric fields which could disrupt the
programming. If you suspect this has occurred, remove the batteries from the unit momentarily and then re-insert them.
12
VALO 3.6VDC Lithium Iron Phosphate smart battery charger:
• A utomatic shut off when fully charged
• A uto-detection of defective batteries
• P rotections: Thermal, Overcharge, Short-circuit, reverse polarity
o R ed LED – Charging
o G reen LED – Empty or Fully Charged
o L ED off – short circuit
• C harging time: 1 – 3 hours
Rating: CE, WEEE
Rechargeable: Safe chemistry Lithium Iron Phosphate (LiFePO
• W orking Voltage: 3.2VDC
Ratings: CE, RoHS, WEEE
Alternate use Non-rechargeable:
Lithium CR-123A 3VDC (use batteries greater than 1400mAh)
Protections: Low Battery, Over Voltage, Over Temperature, LED Failure, Calibration Failure
Limitations for Use: VALO Cordless will not allow operation if temperatures exceed 50°C.
Ratings: Medical Grade, CE, RoHS, WEEE
Weight:
• W ith batteries: 5.5 troy oz. (170 grams)
• W ithout batteries: 4.4 troy oz. (136 grams)
Dimension: (8 x 1.28 x 1.06) inches,
(203 x 32.5 x 27) mm
) RCR123A
4