Renkforce 1519512 Mode D'emploi page 21

• Check the entire product for damage before any commissioning, e.g. damage to the casing and mains
cable/plug.
If you find any damage, the product must not be used.
If the product is already connected to the mains voltage, first switch off all contacts of the associated
mains socket by deactivating the circuit breaker or turning out fuse; then switch off the associated FI
protection switch.
Only unplug the water pump system for home use mains plug from the mains socket now. Do not operate
the product anymore afterwards, but take it to a specialist workshop.
Never perform any repairs on your own. Always leave them to a specialist!
• If you have reason to believe that the water pump system for home use can no longer be operated safely,
disconnect it immediately and make sure it is not unintentionally operated; pull the mains plug from the
socket. It can be assumed that safe operation is no longer possible if:
- the water pump system for home use or connection lines show visible damage
- the water pump system for home use no longer works
- the water pump system for home use has been transported or stored under difficult circumstances
- there has been heavy stress during transport
• Always disconnect the mains plug from the mains socket when you are no longer using the product, for
troubleshooting or for cleaning/maintenance.
• Never pull the mains plug from the mains socket by pulling the cable. Always pull the mains plug from the
mains socket by the lateral grip areas.
Never touch the mains plug with wet or damp hands; danger to life from electric shock!
• Only transport the product by the housing but never by the mains cable.
• If the product is brought from a cold into a warm room (e.g. for transport), it is possible that condensation
will develop. This causes danger to life from electric shock!
Therefore, you should allow the product to warm up to room/ambience temperature before using it or
connecting it to the mains voltage. This may take several hours.
21