Siemens SITRANS FUS1010 Guide Rapide page 44

Appendix A
A.1 I/O Connections and Wiring
Terminal Block Wiring - 1010DXS2-7
(Refer to manual drawing 1010DXS2-7 sheet 3 of 4. When Barriers are used, isolation is limited
to the Barrier's working voltage. Refer to table on manual drawing 1010-341 sheet 3).
These connection diagrams apply to the part numbers listed below.
Table A-4
1010DXS2-7 (Sheet 3 of 4) Drawing
FUS1010
Note
See Table A-2 Wiring diagram for FUS1010DX TB1.
Table A-5
Pin#
10
Note
Wiring diagram for FUS1010DX TB2 is the same as Table A-3.
42
Part Numbers and Connection Diagrams
FUS1010DX Input/Output Wiring (TB1)
Signal Function
1 Io2 - Isolated Loop Return
2 Io2 + Isolated Loop Supply
3 Io1 - Isolated Loop Return
4 Io1 + Isolated Loop Supply
5 ANIN 2 4-20mA Input Ch.2
6 ANIN 1 4-20mA Input Ch.1
7 Status -1 Status Bit Return
8 Status +1 Status Output
9 Status -2 Status Bit Return
Status +2 Status Output
7ME353a-ab
where:
a= 2
b= D or F
Description
4-20mA output
proportional to any
available spanned data
variable
4-20mA Analog input
non-isolated
Ch.2 Status Alarm Emitter User assignable via menu
Ch.1 Status Alarm
Collector
Ch.2 Status Alarm Emitter
Ch.2 Status Alarm
Collector
Operating Instructions, 12/2008, CQO:QSG002 Revision B
4-20mA assignable and
spannable under menu
control.
User assignable depending
on model - may be AUX, PSI,
etc.)
control.
FUS1010 IP65 NEMA 4X Quick Start