Troubleshooting/Faqs; Table 4-1 Troubleshooting Tips - Siemens SITRANS FUS1010 Guide Rapide

Troubleshooting/FAQs

Troubleshooting
The following is list of troubleshooting tips and messages that you may encounter. They include
explanations, and in some cases, a recommended action. If a problem seems unsolvable,
contact your local Siemens Ultrasonic Flow Representative for expert help
(http://www.automation.siemens.com/partner).
Table 4-1 Troubleshooting Tips
Message
Memory Full!
Memory Corrupted!
Chan Not Setup
Clr Active Memory?
Clr Saved Data?
<EOT>
Empty Pipe - Press <ENTER>
Fill Pipe - Press <ENTER>
No Sites - Press <ENTER>
Re-space Index
FUS1010 IP65 NEMA 4X Quick Start
Operating Instructions, 12/2008, CQO:QSG002 Revision B
Description
Response to an attempt to save site data, when data memory
is full. Delete an obsolete site or clear Datalogger memory to
make room for the new data.
Memory read error occurred while accessing the active site
data.
Response to an attempt to invoke an operation that requires
a channel to be enabled. Enable the channel [Channel Setup
- Channel Enable - Yes]. Note that a channel cannot be
enabled until its transducers are operating.
Use this function to restore operation if a severe event (e.g.,
a violent power surge) disrupts system operation. Refer to
flowmeter manual.
Use this function to clear Dynamic Memory. Refer to
flowmeter manual.
Response to a request to output Datalogger data to the
printer or the Graphics screen when no Datalogger data
exists. Set up the Datalogger.
Prompt to empty the pipe during the Actual MTY procedure.
After emptying pipe, trigger <ENTER>.
Prompt to fill the pipe during the Actual MTY procedure. After
filling the pipe, trigger [ENTER]
Response while trying to recall/delete a site setup when no
sites are stored.
Upon measuring the liquid sonic velocity (Vs), the meter
recommends re-spacing the transducers to improve
performance.
4
35