Siemens SITRANS FUS1010 Guide Rapide page 26

Commissioning
3.4 Setting the Parameters
Create a Site
1. Trigger <Right Arrow> and then <Up/Down Arrows> to select [Create/Name Site].
2. Trigger <Right Arrow> again to select the "?" symbol (see figure below right).
3. To create site name use the <Up/Down> and <Right Arrow> to select a name.
4. Trigger <ENTER> sensor to save the Site name.
5. Trigger <Left Arrow> and return to [Channel Setup]. Trigger <Down Arrow> to select [Pipe
Select Pipe Class
1. Trigger <Right Arrow> to select [Pick Pipe Class].
2. Trigger <Right Arrow> again. Trigger the <Up/Down Arrows> to scroll to desired Pipe Class.
3. Trigger <ENTER> to select Pipe Class.
24
1 Note site name field is initially blank.
2 (?) indicates cell is ready to accept data. Cursor shown at 1st character position. Insert desired
name (8 Characters max.)
Note
To set English or Metric units: In Meter Type Menu, scroll to Meter Facilities Menu. Press
<Right Arrow> and select desired units. Press <ENTER> to select. Press <Left Arrow>
and <Up Arrow> to return to Meter Type Menu.
Note
To select alpha-numeric characters: Press <Right Arrow> to cursor and then trigger <Up/
Down Arrow> to select letters and numbers.
Data].
FUS1010 IP65 NEMA 4X Quick Start
Operating Instructions, 12/2008, CQO:QSG002 Revision B