HBM PACEline CMC Manuel D'emploi page 20

20
Example:
Content written by HBM, on the basis of the individual test certificate: Area 3
of the CMC/20kN force measurement chain with identification no. 123456,
made by HBM on 27.6.2007.
Template: High Level Voltage
Parameter
Transducer Electrical
Signal Type
Minimum Force/Weight
Maximum Force/Weight
Minimum Electrical
Value
Maximum Electrical
Value
Mapping Method
AC or DC Coupling
Output Impedance of
the sensor
Response Time
Excitation Level
(Nominal)
Excitation Level
(Minimum)
Excitation voltage Type
Max. current draw at
nominal excitation level
1)
Typical values for the CMC/20kN piezoelectric force measurement chain
HBM
1)
Value Unit
Voltage
Sensor
0.000 N
20.000 k N
0.00000 V/V
+9.95700 V/V
Linear
DC
10.0 Ohm
1.0000000u sec
24.0 V
18.0 V
DC
50.12m A
Change
require
s rights
to level:
ID
CAL
The physical measured quantity and
unit are defined when the template
is created, after which they cannot
CAL
CAL
The difference between these
values is the sensitivity according to
the HBM test certificate or from
CAL
This entry cannot be changed.
ID
ID Output resistance according to the
HBM data sheet.
ID Of no significance for HBM
ID Supply voltage according to the
HBM data sheet
ID Lower limit for the operating range
of the supply voltage according to
the HBM data sheet.
ID Supply voltage type
ID
Maximum supply current
CMC
Explanation
be changed.
calibration 1) .
transducers.
A2319-4.0 en/de/fr