Technical Characteristics Of The Product; Ce Declaration Of Conformity - Nice Moon MC824H Instructions Et Avertissements Pour L'installation Et L'utilisation

WARNINGS: • All technical characteristics stated refer to an ambient temperature of 20°C (±5°C). • Nice S.p.a reserves the right to modify the product at any time while maintaining the
same functionalities and intended use.
MC824H power supply
MC824H/V1 power supply
Nominal power absorbed from mains
Power absorbed from mains in
"standby - All" operation (including a receiver)
Power absorbed by control unit battery
connector with "standby-All" operation
(including a receiver with SM type connector)
Flashing light output [*]
Electric lock output [*]
Gate open light output [*]
BLUEBUS output
STOP Input
PP Input
OPEN Input
CLOSE Input
Radio connector
Radio AERIAL input
Programmable functions
Functions in self-learning mode
Operating temperature
Use in particularly acid, saline or
potentially explosive atmospheres
Protection rating
Dimensions (mm)
Weight (kg)
[*] The Flashing Light, Electric Lock and Gate Open Warning light outputs can be programmed with other functions (see "TABLE 5 - 1st level functions"; or via Oview programmer, see
chapter 7.2). The electrical characteristics of the output vary according to programming:
flashing light: 12Vdc, 21 Wmax lamp
electric lock: 12Vac 15 VAmax
other outputs (all types): 1 lamp or relay 24Vdc (-30 and +50%), 4 Wmax
Note - The contents of this declaration correspond to declarations in the last revision of the official document deposited at the registered offices of Nice Spa available before this manual was printed. The text herein has been re-edited for editorial pur-
poses.
Number: 298/MC824H
The undersigned, Luigi Paro, in the role of Managing Director, declares under his sole responsibility, that the product:
Manufacturer's Name:
Address:
Type:
Models:
Accessories:
Conform with the requirements of the following EC directives:
• 98/37/EC (89/392/EEC amended); DIRECTIVE 98/37/EC OF THE EUROPEAN PARLIAMENT AND COUNCIL of 22 June 1998 regarding the approximation of member state legislation relating
to machinery.
As established in directive 98/37/EC, the above-mentioned product may not be started up unless the machine in which the product is incorporated has been identified and declared as con-
forming to directive 98/37/EC.
The product also complies with the requirements of the following EC directives:
• 2006/95/EEC (ex directive 73/23/EEC); DIRECTIVE 2006/95/EEC OF THE EUROPEAN PARLIAMENT AND COUNCIL of 12 December 2006 regarding the approximation of member state leg-
islation relating to electrical material intended for use within specific voltage limits
According to the following harmonised standards: EN 60335-1:1994+A11:1995+A1:1996+A12:1996+A13:1998+A14:1998+A15:2000+A2:2000+A16:2001
• 2004/108/EEC (ex directive 89/336/EEC); DIRECTIVE 2004/108/EEC OF THE EUROPEAN PARLIAMENT AND COUNCIL of 15 December 2004 regarding the approximation of member state
legislation relating to electromagnetic compatibility, repealing directive 89/336/EEC
According to the following harmonised standards: EN 61000-6-2:2005; EN 61000-6-3:2007.
The product also complies, within the constraints of applicable parts, with the following standards: EN 60335-1:2002+A1:2004+A11:2004+A12:2006+ A2:2006, EN 60335-2-103:2003, EN
13241-1:2003; EN 12453:2002; EN 12445:2002; EN 12978:2003
Oderzo, 11 June 2009
10 – English

TECHNICAL CHARACTERISTICS OF THE PRODUCT

230 Vac (+10% -15%) 50/60 Hz
120 Vac (+10% -15%) 50/60 Hz
200 W
2 W
below 100 mW
1 "LUCYB" type flashing light (12 V, 21 W lamp)
1 max. 12 Vac max. 15 VA electric lock
one 24 V max. 4 W lamp (output voltage may vary between -30% and +50%, output may also control small relays)
1 output with maximum load 15 Bluebus units (maximum 6 pairs of MOFB or MOFOB photocells + 2 pairs of MOFB or MOFOB
photocells assigned as Opening devices + max. 4 MOMB or MOTB control devices
For normally closed, normally open or 8.2 kΩ constant resistance contacts in self-learning mode (a change from the memorised
state prompts the "STOP" command)
for normally open contacts (closure of the contact prompts the Step by Step command)
for normally open contacts (closure of the contact prompts the OPEN command)
for normally open contacts (closure of the contact prompts the CLOSE command)
SM connector for SMXI, OXI and OXIFM family receivers
50 Ω for RG58 or similar type cable
8 ON-OFF type functions and 8 adjustable functions
• Self-learning of devices connected to the BlueBus output
• Self-learning of type of device connected to "STOP" terminal (NO, NC or 8.2 kΩ resistance contact)
• Self-learning of leaf travel and automatic calculation of deceleration and partial opening points (vary according to installation)
from - 20 °C a + 50 °C
NO
IP 54 with enclosure intact
310 x 232 x H 122
4,1

CE DECLARATION OF CONFORMITY

Revision: 1
NICE s.p.a.
Via Pezza Alta 13, Z.I. Rustignè, 31046 Oderzo (TV) Italy
two 24 Vdc motor control unit
MC824H
Radio receiver SMXI, OXI, OXIFM, PS 324, SYKCE, OVIEW unit
Luigi Paro (Managing Director)