Light Bulbs - GE 20 Serie Manuel D'utilisation Et D'installation

Behind the Refrigerator
Be careful when moving the refrigerator away from the wall. All
types of floor coverings can be damaged, particularly cushioned
coverings and those with embossed surfaces.
Pull the refrigerator straight out and return it to position by
pushing it straight in. Moving the refrigerator in a side direction
may result in damage to the floor covering or refrigerator.
When pushing the refrigerator back, make sure you don't
roll over the power cord or icemaker supply line (on some
models).
Preparing for Vacation
For long vacations or absences, remove food and unplug the
refrigerator. Clean the interior with a baking soda solution of
one tablespoon (15 ml) of baking soda to one quart (1 l) of water.
Leave the doors open.
Preparing to Move
Secure all loose items such as grille, shelves and drawers by
taping them securely in place to prevent damage.
Replacing the Light Bulbs
WARNING
Before replacing a burned-out light bulb, the refrigerator should be unplugged in order to avoid contact with a
live wire filament. (A burned-out light bulb may break when being replaced.)
Turning the control to the OFF position does not remove power to the light circuit.
Unplug the refrigerator.
Remove the shelf just below the light shield.
Replace with an appliance bulb of the same or lower
wattage.
Reinstall the shelf and plug the refrigerator back in.
Slide the icemaker power switch to the OFF position and shut
off the water supply to the refrigerator.
Be sure the refrigerator stays in an upright position during
moving.
GEAppliances.com
11