EUROM Wall Designheat 2000 Wi-Fi Manuel D'utilisation page 34


The required temperature can be set using buttons 10 and 11. The display will
momentarily show the required temperature and before returning to the current
temperature. The built-in thermostat will switch off the heating when the desired
temperature has been reached. Once the temperature starts dropping, the heating
will automatically switch back on.
Note! The fan will continue to run for another 30 minutes after the thermostat has
turned off the heating elements. This means that the air is constantly moved, allowing
the heater to accurately detect if the area is cooling down.

Press the ON/OFF button again in order to switch the heater off. When you have been
using the device to provide heat, it will cool off for 30 minutes before switching off
entirely. During cooling, the indicator lamp A will flash on and off. Once the cooling
period has come to an end and the signal light A has gone off, press the main switch 1
to turn off and remove the plug from the socket.
Connection and method of external temperature sensor:
• Because the temperature sensor is on the stove, the measurement is not particularly
accurate. For more accurate measurement, connect the supplied separate thermostat
by plugging the plug into the device and removing the sensor 2 meters from the
heater. When you have plugged in
the separate thermostat, it
automatically takes over the
thermostat operation.
• The fan now continues to run instead
of 30 minutes for 5 minutes after the
thermostat has switched off the
heating elements. The stove keeps
the air in the room moving and is therefore optimally able to feel whether the room is
cooling down.
• To switch the heater off, press the ON / OFF button again. When you have heated up,
the stove will now cool for 5 minutes before it switches off completely. During re-
cooling, the indicator light A flashes. When the after-cooling stops and the indicator
light A has gone out, press the main switch 1 and remove the plug from the socket.
Emergency operation of the appliance
The most important functions of the appliance can be activated without the use of the
remote control.
 By pressing the mode button MODE (2), you can consecutively set: ventilation - heating
at half power - heating at full power - heating at full power with oscillation - off. The
corresponding lamps will light up.
 With the temperature- and Wi-Fi button (3) you can set the temperature: each time
pressing is one degree higher, up to 35°C. After that pressing again will switch back to
10°C.
34