Télécharger Imprimer la page

EUROM Wall Designheat 2000 Wi-Fi Manuel D'utilisation page 33

Masquer les pouces Voir aussi pour Wall Designheat 2000 Wi-Fi:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
Location and connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
Select a suitable location for the device taking into account all the aforementioned
warnings in this manual.
The device has to be hung from a wall and therefore may not be used in a lying,
leaning or standing position!
The heater has to preferably be positioned at and permanently connected to an electric
socket. This connection may only be made by a qualified electrician and, for that reason, is
not described here. In this manual, for reasons of safety, use with a plug should be
assumed; when there is a permanent connection, any passages about the plug do not apply.
Drill two holes in the wall at the required locations to fit the plugs exactly: make sure
these holes are horizontal and 57.5 cm apart. Insert plugs and screws into the holes.
Allow the screws to stick out by 10 mm. Hook the heater over the screws using the
hanging eyes, then lower it down and slide it to the right. The fixing material supplied
is suitable for brick walls. Consult a specialist, for instance at a DIY store, if your wall is
built of other material.
Check whether the heater is secured to the wall; if
necessary insert the screws a little further into the plugs.
Attach the heater using the materials supplied. Place the
bracket on top of the heater (see picture) with the short
side against the wall. Mark the location of the hole on the
wall and remove the heater. Drill a hole at the marked spot
and insert a plug. Now hang the heater in place and screw
the bracket to the wall, as shown in the diagram. The
heater is now installed.
Using for the first time and operation
Make sure that the main switch is OFF (O)
Unroll the electrical cable entirely and insert the plug into a suitable 220-240V socket.
Set the main switch to ON (l). The display will show the current temperature.
With the remote control
Press the ON/OFF button (7): the fan will begin to rotate and the fan indicator lamp A
will light up.
By pressing the MODE button one or more times, you can set the heater to half of full
power or select just fan. The indicator lamp for the chosen mode will light up.
Pressing button 9 (Swing) will start the oscillating function: the flap in front of
discharge vent 5 will move and air will start to flow. This function works while heating
and ventilating. By pressing the button again, the oscillating function is turned off.
33

Publicité

loading

Ce manuel est également adapté pour:

342178342185