EUROM Wall Designheat 2000 Wi-Fi Manuel D'utilisation page 32

- clean the device
- users - maintain the device.
- touch or move the device.
3. Never switch the device on if you have noticed damage to the device itself, the cable
or plug or if it does not work properly, makes strange noises, smells odd or you can
see smoke, or if it has fallen or shows any other signs of damage. Remove the plug
from the socket immediately. Take the entire device back to your supplier or a
recognised electrician to be checked and/or repaired. Always ask for original parts to
be used.
4. The device may only be opened and/or repaired by a competent and qualified
person. Do not carry our your own repairs as this could be dangerous! Repairs carried
out by unauthorised persons or changes made to the device could damage the
dust/waterproof capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the manufacturer, their
service department or somebody with similar qualifications in order to prevent
creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or personal injury. They
will invalidate the guarantee and the supplier, importer and/or manufacturer shall not be
liable for the consequences.
Description
1. Main switch
2. Mode button (MODE)
3. Temperature & Wi-Fi
4. Suction grilles (top side)
5. Air discharge grille
6. Display
12. Connection for external
temperature sensor
Remote control:
7. ON/OFF button
8. Mode switch (MODE)
9. Swing=oscillate
10. Increase temperature
11. Decrease temperature
Display:
A. Ventilation lamp
B. Heating lamp (half power)
C. Heating lamp (full power)
The remote control works on a cell battery, type CR2025 (3V).
D. "Oscillation" lamp
E. Wi-Fi signal found
32