Programming Sw164Osm Matrix - Videotec SW164OSM Manuel D'instructions

5.4

Programming SW164OSM matrix

Only the operator that's controlling output #1 can program the matrix.
During Program mode the alarm handling and switching operation are temporarily suspended.
It is necessary to connect a video signal to input 1.
To begin the set-up procedure
P
Press and, if necessary, insert the set-up password.
Select menu language by pressing
To modify sequence cycles
From the main menu, press
Select the sequence to be modified by pressing the corresponding number.
Each sequence cycle is defined by a maximum of 16
sequence steps indicated by a character from A to P.
Only one of the 16 sequence steps is active and can be
modified (in the example it is step C, marked by two arrows).
Select the active step pressing
The steps from H to P are normally not displayed on screen:
the screen will roll up when necessary to display them.
Select the input to be shown pressing a number from 1 to 16
(a 2-second dwell time is automatically proposed).
Modify the dwell time by pressing
C
and (one second decrease).
To remove a step, enter a time of 0 seconds.
P
confirms the sequence cycle introduced and returns to
the previous menu.
1
until the menu in English is shown.
2
to access SEQUENCE CYCLES submenu.
U D
and .
E
(one second increase)
Sequence to be
modified
Sequence step
Input
Seconds
Page 20
MAIN MENU
------------------------
1. Language: English
2. Sequence cycle
3. Alarms
4. Titles
5. VCR/Printer
6. Date/Time
7. Other parameters
0. Information
------------------------
PROG.End
SEQUENCE CYCLE
------------------------
1. Output 1, Day seq.
2. Output 2, Day seq.
3. Output 3, Day seq.
4. Output 4, Day seq.
6. Output 1, Night seq.
7. Output 2, Night seq.
8. Output 3, Night seq.
9. Output 4, Night seq.
------------------------
PROG.End
SEQUENCE CHANGE
------------------------
Output 1 Seq.Day
Step In Sec
A 05 4 ^.Previous
B 07 10 v.Next.
>C 05 4<
D 02 10 ENT.Plus
E -- - CLR.Minus
F -- -
G -- - PROG.End
SW164OSM 9901
2.
2.1