Louisiana Grills LG800ELITE Instructions Et Utilisation page 8

ASSEMBLING THE CART KIT
Parts Required:
2 x #8 Cabinet End Panels
4 x #9 Legs c/w Casters
1 x #10 Bottom Cabinet Shelf
1 x #12 Cabinet Door Stopper
1 x #15 Rear Cabinet Panel
16 X Screws (AA)
14 X Screws (BB)
Tools Required:
Large Phillips Screwdriver or
Phillips Drive Bit and Drill
Installation:
Step 1 Attach legs to bottom shelf
The bottom portion of each of the legs, #9, has a threaded
plate installed to allow for two (2) locking and two (2)
non-locking casters to be pre-installed.

To ease installation, assemble the entire cart
components on a raised work bench or flat surface.

Ensure that the shelf is facing with the flat surface
facing upwards.

Begin by carefully sliding each of the four (4) legs
into the correct cut-out, ensuring the screw hole
patterns match.
NOTE: It is best to start each threaded screw by
hand, to ensure the thread DOES NOT
cross thread or strip.

Using a Phillips head driver, install four (4) of the supplied (AA),
sixteen (16) in total, screws into each leg, to secure each leg to the
shelving unit.
Ensure that ALL screws are firmly, hand-tight, secured.
Step 2 Attach the cabinet side walls
The two (2) vented side panels, #8, are each pre-drilled with four (4) holes to
match the hole pattern found on each leg. The finished face
should face outwards and should be flush to the legs.

Starting on one end, line up face panel to the legs.

Hand start each of the four (4) screws (BB) through the
panel and into each leg. Eight (8) in total.

Using a Phillips head driver, firmly secure each screw.

Repeat procedure for the second side.
8
Assembly Instruction
C
c
8