Louisiana Grills LG800ELITE Instructions Et Utilisation page 15

INSTALLING THE SIDE SHELF:
Parts Required:
1 x #19 Side Shelf—Left Mounting Bracket
1 x #20 Side Shelf—Right Mounting Bracket
1 x #21 Side Shelf— 10" Long Chrome Hanger Bar w/screws
4 x #22 Side Shelf— Tool Hanger w/nuts
1 x #23 Side Shelf Top
8 x Multi-Head Screws (BB)
Tools Required:
Large Phillips Screwdriver or
Phillips Drive Bit and Drill
Installation:
Step 1 # 22 Tool Hangers

Remove the nuts from all four (4) tool hangers.

Insert individual tool hanger into the four (4) holes provided in
the side shelf top, # 23.

Hand tighten each nut, Then tighten to a snug, secure
fit, using a wrench.
Step 2 # 21 Chrome Hanger Bar

Remove the two (2) screws from the bar hanger.

Insert the screws through the two (2) holes provided in the front
of the side shelf top, # 23.

Using a Phillips screwdriver to tighten to a snug, secure fit.
Step 3 # 20 Right (rear) Mounting Bracket & # 19 Left (front) Mounting Bracket

Line up the two (2) holes on the mounting bracket with
the two (2) holes provided on the side shelf top, #23
The straight finished face of the bracket will be flush
with shelf.

Using two (2) multi-heads screws (BB) hand start then
tighten using a screwdriver.
Step 4 Side shelf to Cabinet
There are four (4) screws (BB) used to secure the shelf to
the cabinet. Two (2) through the shelf itself, see II, and one
(1) through each of the mounting brackets #19 & #20, see I.

Begin by hand starting each of the four (4) screws, then
using a Phillips screwdriver tighten to a firm, secure
fit.
WARNING!
Extreme care must be taken when
lifting the LG Elite 800. The side shelf
is NOT intended for lifting. Use the
lifting handles, # 27 found on the rear
of the cabinet.
Assembly Instructions
15
15