Louisiana Grills LG800ELITE Instructions Et Utilisation page 17

INSTALLING THE DOORS AND DRAWER:
Parts Required:
1 x #13 Left Side Cabinet Door - Assembled
1 x #14 Right Side Cabinet Door - Assembled
1 x #18 Grease Drawer - Assembled
Cabinet Doors

To install the cabinet doors simply PUSH down on the
top door hinge pin (see diagram ) while inserting the
bottom door hinge pins into the holes supplied in the
bottom shelf.

When the top door hinge pin is lined up with the top
Cabinet holes, release the spring loaded pins.
Grease Drawer

Simply slide the drawer into the opening supplied.
TIP
To aid in cleaning and reduce maintenance, line the
grease drawer with foil, or a thin layer of sand.
FINAL INSPECTION AND CLEANING:
ALWAYS clean dirt, dust and oils from ALL stainless steel surfaces before you use the unit. This can
cook into the metal and discolor it.
Using a soft cloth and hot soapy water, thoroughly clean all surfaces and ensure all screws are secure.
Stainless Steel Cleaner and a soft rag can be used on all stainless surfaces.
HOOKING UP TO POWER:
AT HOME
 This appliance requires 110 Volt, 60Hz, 5amp service.
It must use a 3 prong grounded plug.

The "Digital Control Center" Oven Temp Control uses a 1 1/4" x 1/4", 5 amp 110 volt

to protect the board..
GFI Outlets
This appliance will work on most GFI Outlets. Recommended size 15 amp.

 If your GFI outlet is highly sensitive to power surges, it will very likely trip during the ignition
phase of operation. During the ignition phase, the igniter is drawing 300—700 watts of
electricity which can be too much power for a GFI outlet to handle. The quality of the GFI
does not matter, rather the sensitivity. Each time a GFI trips it does increase in sensitivity.
Solution: 1. Install a brand new GFI .
2. Plug the appliance into a non-GFI outlet.
ON THE ROAD

By disconnecting the Igniter, from the main wiring harness, your grill can be run
using a 12 volt , 100 watt "POSITIVE WAVE LENGTH" inverter plugged into
your automobile outlet. Then light your smoker using the manual method.
(found in lighting instructions)

If you do want to continue to use the automatic igniter, it is recommended to use
a minimum of a 1000 watt "POSITIVE WAVE LENGTH" inverter.
Assembly Instructions
17
17