Louisiana Grills LG800ELITE Instructions Et Utilisation page 14

INSTALLING THE COOKING GRIDS:
Parts Required:
3 x #24 Cast Iron Grids
1 x #25 Porcelain Upper Grid
Installation:

Your LG Elite 800 Series Smoker comes complete
With three (3) Cast Iron Cooking Grids, #24 and
One (1) Porcelain Upper Cooking Grid, #25 for the
upper cooking rack.

NOTE: To maintain the searing and grilling performance of
your grid, as well as their longevity, some special care and
maintenance is required. (refer to maintenance section)
INSTALLING THE MAIN LID HANDLE:
Parts Required:
Large Phillips Screwdriver or
Phillips Drive Bit and Drill
Installation:
 Insert one screw through the hole provided in the barrel hood.
 Install the cardboard washer, then metal bezel on the screw end
sticking through the barrel.
 Hand thread and tighten this screw to one of the ends of the one
piece stainless steel handle.
 Follow the same procedure to secure the other end of the handle to
the barrel.
 Using a Phillips screwdriver, firmly tighten both bolts until handle
feels firm.
CAUTION!
DO NOT OVERTIGHTEN! Only a snug fit is required.
INSTALLING THE DOME THERMOMETER:
Parts Required:
Installation:
The thermometer comes complete with its own threaded nut already
installed on the thermometer.
Simply spin off the threaded nut and small washer.

Insert the dome thermometer, thru the large bezel and protective felt, before

inserting through the hole provided in the top of the hood.
Then firmly hand tighten the nut back onto the thermometer.

NOTE: Do not tighten by spinning the head of the thermometer.
14
Assembly Instructions
2 x Multi Head Screws (AA)
2 x Bezel—Decorative Washer
2 x Felt Washers
1 x Stainless Steel Handle
Dome Thermometer
Large Protective Felt
Large Bezel—Decorative Washer
Washer and 9/16" Nut
Bolt
14