Ottobock 17AD100 Instructions D'utilisation page 36

NOTICE
Thermal overloading of the product
Damage due to improper thermal treatment
► Do not carry out any heat treatment at temperatures above 300 °C
(570 °F).
► Prior to thermal treatment, remove all temperature-critical components
(such as plastic parts).
NOTICE
Thermal overloading of product components
Loss of function due to improper thermal treatment
► Prior to the thermal treatment of the product, remove all temperature-
critical components (e.g. plastic parts).
NOTICE
Exposure of the product to unsuitable environmental conditions
Damage, brittleness or destruction due to improper handling
► Avoid storage in condensing ambient humidity.
► Avoid contact with abrasive substances (e.g. sand, dust).
► Do not expose the product to temperatures below -10 °C (14 °F) or
above +60 °C (140 °F) (e.g. sauna, excessive sunlight, drying on a
radiator).
6 Preparing the product for use
CAUTION
Incorrect alignment, assembly or adjustment
Risk of injury due to change in or loss of functionality
► Assembly, adjustment and maintenance operations may only be com­
pleted by qualified personnel.
► Observe the alignment, assembly and adjustment instructions.
6.1 Processing
Required materials:
17AD100A=DY-*-P lamination dummy cover, 17LS3=* lamination bar or
17LV3=* side bar, 17SF100=OS*/17SF101=OS* foot stirrup, 501S137=*
countersunk head screws, 743Y56=4 alignment insert, 636K8 Plastaband
36
17AD100A=DY* lamination dummy set,