Wheels And Tires - Textron E-Z-GO Shuttle 2 2007 Manuel D'exploitation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
When lifting vehicle, position jacks and jack stands at the
areas indicated only.
To raise the entire vehicle, install chocks in front and
behind each front wheel (Ref Fig. 11 on page 9). Center
the jack under the rear frame crossmember. Raise the
vehicle enough to place a jack stand under the outer
ends of the rear axle.
Lower the jack and test the stability of the vehicle on the
two jack stands.
Place the jack at the center of the front axle. Raise the
vehicle enough to place jack stands under the frame
crossmember as indicated.
Lower the jack and test the stability of the vehicle on all
four jack stands.
If only the front or rear of the vehicle is to be raised, place
the chocks in front and behind each wheel not being
raised to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
Center of
Front Axle
View From Underside Of Vehicle
Fig. 11 Lifting the Vehicle
OPERATION AND SERVICE INFORMATION
Flat Portion
of Frame
Center
Outside End
of Rear
of Rear Axle
Bumper
Owner's Manual and Service Guide

WHEELS AND TIRES

Tire Repair
Tool List
Lug wrench, 3/4" ......................................................... 1
Impact socket, 3/4", 1/2" drive..................................... 1
Impact wrench, 1/2" drive ............................................ 1
Torque wrench, 1/2" drive............................................ 1
A tire explosion can cause severe injury or
death. Never exceed inflation pressure rating
on tire sidewall.
To reduce the possibility of tire explosion,
pressurize tire with small amount of air
applied intermittently to seat beads. Due to
the low volume of the small tires, overinfla-
tion can occur in seconds. Never exceed
the tire manufacturer's recommendation
when seating a bead. Protect face and eyes
from escaping air when removing valve
core.
To reduce the possibility of severe injury
caused by a broken socket when removing
wheels, use only sockets designed for
impact wrench use.
Use caution when inflating tires. Overinfla-
tion could cause the tire to separate from
the wheel or cause the tire to explode,
either of which could cause severe injury.
Do not use low inflation pressure tires on
any E-Z-GO vehicle. Do not use any tire
which has a recommended inflation pres-
sure less than the inflation pressure recom-
mended in Owner's Manual.
Use caution when inflating tires. Due to the low volume of
the small tires, overinflation can occur in seconds. Over-
inflation could cause the tire to separate from the wheel
or cause the tire to explode.
Tire inflation should be determined by the condition of the
terrain. See GENERAL SPECIFICATIONS section for
recommended tire inflation pressure. For outdoor appli-
cations with major use on grassy areas, the following
should be considered. On hard turf, it is desirable to have
a slightly higher inflation pressure. On very soft turf, a
lower pressure reduces the possibility of tires cutting into
the turf. For vehicles being used on paved or hard sur-
Qty. Required
Page 9

Publicité

Chapitres

Table des Matières
loading

Produits Connexes pour Textron E-Z-GO Shuttle 2 2007

Ce manuel est également adapté pour:

E-z-go shuttle 4 2007E-z-go shuttle 6 2007E-z-go te5 2007

Table des Matières